CLOCK INSPECTION

< Previous Next >

2014 - Mazda6 - Body and Accessories

CLOCK INSPECTION

1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.5].)

2. Remove the following parts:
a. Shift lever knob (MTX) (See MANUAL TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION [C66M-R].)

b. Front console box (See FRONT CONSOLE BOX REMOVAL/INSTALLATION.)

c. Shift panel (See SHIFT PANEL REMOVAL/INSTALLATION.)

d. Upper panel (See UPPER PANEL REMOVAL/INSTALLATION.)

e. Rear console (See REAR CONSOLE REMOVAL/INSTALLATION.)

f. Side wall (See SIDE WALL REMOVAL/INSTALLATION.)

g. Decoration panel (See DECORATION PANEL REMOVAL/INSTALLATION.)

h. Front console (See FRONT CONSOLE REMOVAL/INSTALLATION.)

i. Glove compartment (See GLOVE COMPARTMENT REMOVAL/INSTALLATION.)

j. Climate control unit (See CLIMATE CONTROL UNIT REMOVAL/INSTALLATION [MANUAL AIR CONDITIONER].)

3. Connect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.5].)

4. Verify that the voltages of each of the terminals are as indicated in the terminal voltage table (reference).

If the voltage is not as specified in the terminal voltage table (reference), inspect the parts under Inspection item(s).

If the system does not operate normally even though the inspection items are normal, replace the clock.

Terminal Voltage Table (Reference)


Terminal	Signal name	Connected to	Measurement conditions	Voltage (V)	Inspection item(s)
A	Power position (1G1)	IG relay	Ignition switch ON (engine off or on)	B+	METER1 10 A fuse IG relay Related wiring harness
A	Power position (1G1)	IG relay	Ignition switch OFF (LOCK) or ACC	1.0 or less	METER1 10 A fuse IG relay Related wiring harness
B	Power supply	ROOM 15 A fuse	Under any condition	B+	ROOM 15 A fuse Related wiring harness
C	Power supply (ACC)	ACC relay	Ignition switch ACC	B+	ACC relay AUDIO2 7.5 A fuse Related wiring harness
C	Power supply (ACC)	ACC relay	Ignition switch OFF (LOCK) or ON (engine off or on)	1.0 or less	ACC relay AUDIO2 7.5 A fuse Related wiring harness
D	Seat warmer switch signal	Seat warmer unit	Because this terminal is for communication, good/no good judgment by terminal voltage is not possible.		Related wiring harness
E	MS-CAN_H	CAN communication related module	Because this terminal is for communication, determination using terminal voltage inspection is not possible.
F	Ground	Body ground	Under any condition	1.0 or less	Related wiring harness
G	MS-CAN_L	CAN communication related module	Because this terminal is for communication, determination using terminal voltage inspection is not possible.

< Previous Next >