Description

Front body control module (FBCM) power supply voltage high input

Detection condition

• Front body control module (FBCM) power supply circuit voltage of 14.2 V or more is detected for 10 s or more with the ignition switched ON (engine off or on).

Fail-safe function

Not applicable

Possible cause

• DTCs are stored in the PCM.

• Battery malfunction

• Generator malfunction

• Front body control module (FBCM) malfunction

System wiring diagram

Not applicable

Step

Inspection

Action

1

• Clear the DTC for the front body control module (FBCM) using the M-MDS.

  (See CLEARING DTC [FRONT BODY CONTROL MODULE (FBCM)].)

• Switch the ignition ON (engine off or on) and wait for 10 s or more.

• Retrieve the front body control module (FBCM) DTCs using the M-MDS.

  (See DTC INSPECTION [FRONT BODY CONTROL MODULE (FBCM)].)

• Is the same DTC displayed?

Yes

Go to the next step.

No

Go to Step 6.

2

• Retrieve the PCM DTCs using the M-MDS.

  (See ON-BOARD DIAGNOSTIC TEST [SKYACTIV-G 2.5].)

• Are any DTCs displayed?

Yes

Repair or replace the malfunctioning part according to the applicable DTC troubleshooting.

(See DTC TABLE [SKYACTIV-G 2.5].)

No

Go to the next step.

3

• Inspect the battery.

  (See BATTERY INSPECTION [SKYACTIV-G 2.5].)

• Is the battery normal?

Yes

Go to the next step.

No

Replace the battery, then go to Step 5.

(See BATTERY REMOVAL/INSTALLATION [SKYACTIV-G 2.5].)

4

• Inspect the generator.

  (See GENERATOR INSPECTION [i-ELOOP].)

  (See GENERATOR INSPECTION [SKYACTIV-G 2.5 (WITHOUT i-ELOOP)].)

• Is the generator normal?

Yes

Go to the next step.

No

Replace the generator, then go to the next step.

(See GENERATOR REMOVAL/INSTALLATION [i-ELOOP].)

(See GENERATOR REMOVAL/INSTALLATION [SKYACTIV-G 2.5 (WITHOUT i-ELOOP)].)

5

• Clear the DTC for the front body control module (FBCM) using the M-MDS.

  (See CLEARING DTC [FRONT BODY CONTROL MODULE (FBCM)].)

• Switch the ignition ON (engine off or on) and wait for 10 s or more.

• Retrieve the front body control module (FBCM) DTCs using the M-MDS.

  (See DTC INSPECTION [FRONT BODY CONTROL MODULE (FBCM)].)

• Is the same DTC displayed?

Yes

Repeat the inspection from Step 1.

• If the malfunction recurs, replace the front body control module (FBCM).

  (See FRONT BODY CONTROL MODULE (FBCM) REMOVAL/INSTALLATION.)

Go to the next step.

No

Go to the next step.

6

• Are any other DTCs displayed?

Yes

Repair or replace the malfunctioning part according to the applicable DTC troubleshooting.

(See DTC TABLE [FRONT BODY CONTROL MODULE (FBCM)].)

No

DTC troubleshooting completed.