< Previous   Next >

2014 - Mazda6 - Restraints

DTC B0001:55/B0010:55 [TWO-STEP DEPLOYMENT CONTROL SYSTEM]



System malfunction location

  • B0001:55:Configuration setting error (driver-side air bag module (inflator No.1) structural malfunction)

  • B0010:55:Configuration setting error (passenger-side air bag module (inflator No.1) structural malfunction)

Detection condition

WARNING:

  • Detection conditions are for understanding the DTC outline before performing an inspection. Performing an inspection according to only the detection conditions may cause injury due to an operating error, or damage the system. When performing an inspection, always follow the inspection procedure.

  • SAS control module configuration setting has not been done correctly

  • Parts which have not been set to SAS control module are assembled

Fail-safe

Not applicable

Possible cause

  • SAS control module configuration setting not implemented

  • SAS control module configuration setting invalid

  • Driver or passenger-side air bag module assembly incorrect

  • SAS control module malfunction

System wiring diagram

Not applicable

Diagnostic Procedure



Step

Inspection

Action

1

 PERFORM SAS CONTROL MODULE CONFIGURATION (AS-BUILT DATA USE)

Yes

Go to the next step.

No

DTC troubleshooting completed.

2

 INSPECT AIR BAG MODULE

  • Verify that the driver or passenger-side air bag module is correctly installed.

  • Is the driver or passenger-side air bag module correctly installed?

Yes

Go to the next step.

No

Correctly Install the driver or passenger-side air bag module.

Then go to the next step.

3

 PERFORM SAS CONTROL MODULE DTC INSPECTION

Yes

Replace the SAS control module. (See SAS CONTROL MODULE REMOVAL/INSTALLATION [TWO-STEP DEPLOYMENT CONTROL SYSTEM].)

No

DTC troubleshooting completed.



< Previous   Next >
Back to Top
© 2012 Mazda North American Operations, U.S.A.