TROUBLESHOOTING ITEM

Starter does not work

DESCRIPTION

• Starter does not work even when in P or N position.

POSSIBLE CAUSE

• Wiring harness between TCM terminal J and PCM terminal 2BD malfunction

• Wiring harness between TCM terminal J, start stop unit terminal 1F and LF control unit terminal K malfunction (With advanced keyless entry system)

• Immobilizer system operating or system malfunction

• Engine control system malfunction

STEP

INSPECTION

ACTION

1

• Switch the ignition off.

• Disconnect the PCM connector.

• Disconnect the TCM connector.

• Visually inspect for pin deformity, open circuit, or wiring harness non-insulation between TCM terminal J and PCM terminal 2BD.

• Is there any malfunction?

Yes

Repair or replace any malfunctioning parts according to the inspection result.

No

Without advanced keyless entry system:

• Go to step3.

With advanced keyless entry system:

• Go to the next step.

2

• Switch the ignition off.

• Disconnect the start stop unit connector.

• Disconnect the TCM connector.

• Disconnect the LF control unit connector.

• Visually inspect for pin deformity, open circuit, or wiring harness non-insulation between TCM terminal J, start stop unit terminal 1F and LF control unit terminal K.

• Is there any malfunction?

Yes

Repair or replace any malfunctioning parts according to the inspection result.

No

Go to the next step.

3

• Perform the symptom troubleshooting “NO.3 WILL NOT CRANK”.

  (See NO.3 WILL NOT CRANK [SKYACTIV-G 2.5].)

• Is there any malfunction?

Yes

Repair or replace any malfunctioning parts according to the inspection result.

No

Symptom troubleshooting is completed.