1. Remove the transaxle. (See MANUAL TRANSAXLE REMOVAL/INSTALLATION [C66M-R] (MTX).) (See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION [FW6A-EL] (ATX).)
2. Remove the flywheel (MTX) or the drive plate (ATX). (See CLUTCH UNIT REMOVAL/INSTALLATION [C66M-R] (MTX).) (See DRIVE PLATE REMOVAL/INSTALLATION [FW6A-EL] (ATX).)
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
| 1 | Rear oil seal (See Rear Oil Seal Removal Note.) |
1. Cut the oil seal lip using a utility knife.
2. Remove the oil seal using a flathead screwdriver with the tip protected by a clean cloth to prevent damage to the oil seal sliding part of the crankshaft.
1. Apply clean engine oil to the inner surface of a new rear oil seal.
2. Insert the rear oil seal into the cylinder block by hand.
3. Tap the oil seal in evenly using the SST and a hammer.
Rear oil seal press on amount
0—0.5 mm {0—0.019 in}