DTC P117A:00

Engine oil temperature is high

DETECTION CONDITION

• With the transmission in 5th gear or lower gear, an engine speed of 5,800 rpm continues for 6 min.

Diagnostic support note

• This is a continuous monitor (other).

• The check engine light does not illuminate.

• FREEZE FRAME DATA (Mode 2)/Snapshot data is not available.

• DTC is stored in the PCM memory.

FAIL-SAFE FUNCTION

• Limits intake air amount

POSSIBLE CAUSE

• High engine speed condition continues

• PCM malfunction

STEP

INSPECTION

ACTION

1

• Verify related Service Bulletins and/or on-line repair information availability.

• Is any related repair information available?

Yes

Perform repair or diagnosis according to the available repair information.

• If the vehicle is not repaired, go to the next step.

No

Go to the next step.

2

• Switch the ignition off, then ON (engine off).

• Perform the Pending Trouble Code Access Procedure and DTC Reading Procedure.

  (See ON-BOARD DIAGNOSTIC TEST [SKYACTIV-G 2.5].)

• Is the PENDING CODE/DTC P0335:00 also present?

Yes

Go to the applicable PENDING CODE or DTC inspection.

(See DTC P0335:00 [SKYACTIV-G 2.5].)

No

Go to the next step.

3

• Verify how the customer drives the vehicle by asking the customer the following:

• Does the engine speed exceed 5,800 rpm for 6 min or more while driving in 5th gear or lower gear?

Yes

Explain to the customer that the vehicle is normal (performs control to protect the engine due to continuous engine speed exceeding 5,800 rpm for 6 min or more while in 5th gear or lower gear).

If there is a concern with customer’s driving, provide the customer some pertinent advice (such as gear selection, how to use manual mode).

No

Go to the next step.

4

• Always reconnect all disconnected connectors.

• Clear the DTC from the PCM memory using the M-MDS.

  (See AFTER REPAIR PROCEDURE [SKYACTIV-G 2.5].)

• Perform the Drive Mode 03 (Variable Valve Timing, A/F Sensor Heater, HO2S Heater, A/F Sensor, HO2S and TWC Repair Verification Drive Mode).

  (See OBD-II DRIVE MODE [SKYACTIV-G 2.5].)

• Is the same DTC present?

Yes

Repeat the inspection from Step 1.

• If the malfunction recurs, replace the PCM.

  (See PCM REMOVAL/INSTALLATION [SKYACTIV-G 2.5].)

Go to the next step.

No

Go to the next step.

5

• Perform the “AFTER REPAIR PROCEDURE”.

  (See AFTER REPAIR PROCEDURE [SKYACTIV-G 2.5].)

• Are any DTCs present?

Yes

Go to the applicable DTC inspection.

(See DTC TABLE [SKYACTIV-G 2.5].)

No

DTC troubleshooting completed.