DTC P050B:00

Cold start ignition timing performance problem

DETECTION CONDITION

• PCM internal RAM malfunction.

Diagnostic support note

• This is a continuous monitor (cold start emission reduction strategy monitoring).

• The check engine light illuminates if the PCM detects the above malfunction condition in two consecutive drive cycles or in one drive cycle while the DTC for the same malfunction has been stored in the PCM.

• PENDING CODE is available if the PCM detects the above malfunction condition during first drive cycle.

• FREEZE FRAME DATA (Mode 2)/Snapshot data is available.

• DTC is stored in the PCM memory.

FAIL-SAFE FUNCTION

Not applicable

POSSIBLE CAUSE

• PCM internal RAM malfunction

SYSTEM WIRING DIAGRAM

Not applicable

STEP

INSPECTION

ACTION

1

• Perform the Freeze Frame PID Data Access Procedure.

  (See ON-BOARD DIAGNOSTIC TEST [SKYACTIV-G 2.5].)

• Is the DTC P050B:00 on FREEZE FRAME DATA (Mode 2)?

Yes

Go to the next step.

No

Go to the troubleshooting procedure for DTC on FREEZE FRAME DATA (Mode 2).

(See DTC TABLE [SKYACTIV-G 2.5].)

2

• Have the FREEZE FRAME DATA (Mode 2)/snapshot data and DIAGNOSTIC MONITORING TEST RESULTS (cold start emission reduction strategy monitoring related) been recorded?

Yes

Go to the next step.

No

Record the FREEZE FRAME DATA (Mode 2)/snapshot data and DIAGNOSTIC MONITORING TEST RESULTS on the repair order, then go to the next step.

3

• Verify related Service Bulletins and/or on-line repair information availability.

• Is any related repair information available?

Yes

Perform repair or diagnosis according to the available repair information.

• If the vehicle is not repaired, go to the next step.

No

Go to the next step.

4

• Clear the DTC from the PCM memory using the M-MDS.

  (See AFTER REPAIR PROCEDURE [SKYACTIV-G 2.5].)

• Start the engine and warm it up completely.

• Perform the Pending Trouble Code Access Procedure.

  (See ON-BOARD DIAGNOSTIC TEST [SKYACTIV-G 2.5].)

• Is the PENDING CODE for this DTC present?

Yes

Replace the PCM, then go to the next step.

(See PCM REMOVAL/INSTALLATION [SKYACTIV-G 2.5].)

No

Go to the next step.

5

• Perform the “AFTER REPAIR PROCEDURE”.

  (See AFTER REPAIR PROCEDURE [SKYACTIV-G 2.5].)

• Are any DTCs present?

Yes

Go to the applicable DTC inspection.

(See DTC TABLE [SKYACTIV-G 2.5].)

No

DTC troubleshooting completed.