< Previous   Next >

2014 - Mazda6 - Body and Accessories

REAR BELTLINE MOLDING REMOVAL/INSTALLATION

CAUTION:

1. Fully open the rear door glass.
2. Insert a tape-wrapped flathead screwdriver and detach clip A in the direction of arrow (1) shown in the figure.

3. Pull up the rear belt line molding in the direction of arrow (2) shown in the figure.
4. Insert a tape-wrapped flathead screwdriver and then detach clips A in the direction of arrow (3) shown in the figure.

5. Pull up the rear side of rear beltline molding in the direction of arrow (4) shown in the figure.
6. Rotate the rear beltline molding in the direction of the arrow (5) shown in the figure and remove it while detaching tabs B.
7. Install in the reverse order of removal.


< Previous   Next >
Back to Top
© 2012 Mazda North American Operations, U.S.A.