1. Switch the ignition ON (engine off or on).
2. Move the vehicle to a place with a showroom level of brightness.
3. Verify that the indicator light is illuminated.
4. Verify that the indicator light switches when the auto-dimming mirror on switch/off switch is pressed.
5. While the indicator light is illuminated, verify that the mirror surface brightens.
6. Cover the front light sensor with a hand and verify that the mirror surface darkens when light is shone on the rear light sensor.
7. Remove your hand covering the front light sensor and verify that the mirror surface brightens.
If the auto-dimming mirror does not operate, inspect the terminal voltage. (See Terminal Voltage Table (Reference).)
1. Measure the voltage at each terminal.
If the voltage is not as specified in the Terminal Voltage Table (Reference), inspect the parts under “Inspection item (s)” and related wiring harnesses.
If the system does not work properly even though the inspection items or related wiring harnesses do not have any malfunction, replace the auto-dimming mirror.
| Terminal | Signal name | Connected to | Measured condition | Voltage (V) | Inspection item(s) |
| A | — | — | — | — | — |
| B | IG1 | C/U IG1 15A fuse | Switch the ignition ON (engine on or off) | B+ |
|
| Switch the ignition OFF (LOCK) | 1.0 or less |
||||
| C | — | — | — | — | — |
| D | R position signal | Rear body control module (RBCM) | R position | B+ |
|
| Other than R position | 1.0 or less |
||||
| E | GND | Power outer mirror (LH) | Under any condition | 1.0 or less |
|
| F | GND | Body ground | Under any condition | 1.0 or less |
|
| G | Power output | Power outer mirror (LH) | Auto-dimming mirror operation | 0.4—1.2 |
|
| Other | 1.0 or less |
||||
| H | — | — | — | — | — |
| I | — | — | — | — | — |
| J | Power supply | ROOM 15 A fuse | Under any condition | B+ |
|