1. Connect the M-MDS to the DLC-2.
2. After the vehicle is identified, select the following items from the initialization screen of the M-MDS.a. Select “Self Test”.b. Select “All CMDTCs”.
3. Verify the DTC according to the directions on the screen.
If any DTCs are displayed, perform troubleshooting according to the corresponding DTC inspection after recording the snapshot data.
4. After completion of repairs, clear all DTCs stored in the forward sensing camera (FSC). (See CLEARING DTC [FORWARD SENSING CAMERA (FSC)].)
1. Connect the M-MDS to the DLC-2.
2. After the vehicle is identified, select the following items from the initialization screen of the M-MDS.a. Select “Self Test”.b. Select “Modules”.c. Select “FSC”.
3. Verify the DTC according to the directions on the screen.
If any DTCs are displayed, perform troubleshooting according to the corresponding DTC inspection after recording the snapshot data.
4. After completion of repairs, clear all DTCs stored in the forward sensing camera (FSC). (See CLEARING DTC [FORWARD SENSING CAMERA (FSC)].)
NOTE:
The forward sensing camera (FSC) stores the following two types of snapshot data (vehicle information) when a DTC is detected and displays them in the M-MDS.
Vehicle information detected by forward sensing camera (FSC)
Vehicle information detected by instrument cluster and received by forward sensing camera (FSC) via CAN signal
—: Not applicable
The data for all DTCs currently detected is stored.
| Snapshot data item | Unit | Data contents | Data read/use method | Corresponding data monitor items |
|
| ECU_IN_TMP | °C | °F | ECU Internal Temperature | — | — |
| IG-ON_TIMER | hh:mm:ss*1 | Elapsed time since ignition was switched ON (engine off or on) NOTE:
|
| — |
|
| OPE_MODE | Normal/CALIBRATION/EMERGENCY | Operation Mode | — | — |
|
| VSPD | KPH | MPH | Vehicle speed | — | — |