Description

Remote transmitter registration work not completed

Detection condition

• Start stop unit detects that the registration of a remote transmitter has not been completed.

Fail-safe function

Not applicable

Possible cause

• DTCs are stored in the immobilizer system.

• Start stop unit configuration error

• Remote transmitter registration not completed correctly.

• Start stop unit malfunction

System wiring diagram

Not applicable

Step

Inspection

Action

1

• Retrieve the immobilizer system DTCs using the M-MDS.

  (See DTC INSPECTION [IMMOBILIZER SYSTEM].)

• Are any DTCs displayed?

Yes

Repair or replace the malfunctioning part according to the applicable DTC troubleshooting.

(See DTC TABLE [IMMOBILIZER SYSTEM].)

No

Go to the next step.

2

• Using the M-MDS, perform the start stop unit configuration (using As-Built data).

  (See START STOP UNIT CONFIGURATION (USING AS-BUILT DATA).)

• Clear the DTC for the start stop unit using the M-MDS.

  (See CLEARING DTC [START STOP UNIT].)

• Retrieve the start stop unit DTCs using the M-MDS.

  (See DTC INSPECTION [START STOP UNIT].)

• Is the same DTC displayed?

Yes

Using the M-MDS, perform the start stop unit configuration (using As-Built data) again, then go to the next step.

(See START STOP UNIT CONFIGURATION (USING AS-BUILT DATA).)

No

Go to Step 5.

3

• Register the remote transmitter.

  (See IMMOBILIZER SYSTEM-RELATED PARTS PROGRAMMING.)

• Clear the DTC for the start stop unit using the M-MDS.

  (See CLEARING DTC [START STOP UNIT].)

• Retrieve the start stop unit DTCs using the M-MDS.

  (See DTC INSPECTION [START STOP UNIT].)

• Is the same DTC displayed?

Yes

Go to the next step.

No

Go to Step 5.

4

• Clear the DTC for the start stop unit using the M-MDS.

  (See CLEARING DTC [START STOP UNIT].)

• Retrieve the start stop unit DTCs using the M-MDS.

  (See DTC INSPECTION [START STOP UNIT].)

• Is the same DTC displayed?

Yes

Repeat the inspection from Step 1.

• If the malfunction recurs, replace the start stop unit.

  (See START STOP UNIT REMOVAL/INSTALLATION.)

Go to the next step.

No

Go to the next step.

5

• Are any other DTCs displayed?

Yes

Repair or replace the malfunctioning part according to the applicable DTC troubleshooting.

(See DTC TABLE [START STOP UNIT].)

No

DTC troubleshooting completed.