Description

Trunk lid opener switch (interior) circuit malfunction

Detection condition

• Rear body control module (RBCM) detects a short to ground in trunk lid opener switch (interior) circuit

Fail-safe function

Not applicable

Possible cause

• Trunk lid opener switch (interior) connector or terminal malfunction

• Trunk lid opener switch (interior) malfunction

• Rear body control module (RBCM) connector or terminal malfunction

• Short to ground in wiring harness between rear body control module (RBCM) terminal 2O and trunk lid opener switch (interior) terminal A

• Rear body control module (RBCM) malfunction

Step

Inspection

Action

1

• Clear the DTC for the rear body control module (RBCM) using the M-MDS.

  (See CLEARING DTC [REAR BODY CONTROL MODULE (RBCM)].)

• Retrieve the rear body control module (RBCM) DTCs using the M-MDS.

  (See DTC INSPECTION [REAR BODY CONTROL MODULE (RBCM)].)

• Is the same DTC displayed?

Yes

Go to the next step.

No

Go to Step 7.

2

• Switch the ignition off.

• Disconnect the negative battery cable.

  (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.5].)

• Disconnect the trunk lid opener switch (interior) connector.

• Inspect the connector engagement and connection condition and inspect the terminals for damage, deformation, corrosion, or disconnection.

• Is the connector normal?

Yes

Go to the next step.

No

Repair or replace the connector, then go to Step 6.

3

• Inspect the trunk lid opener switch (interior).

  (See TRUNK LID OPENER SWITCH INSPECTION.)

• Is the trunk lid opener switch (interior) normal?

Yes

Go to the next step.

No

Replace the trunk lid opener switch (interior), then go to Step 6.

(See TRUNK LID OPENER SWITCH REMOVAL/INSTALLATION.)

4

• Disconnect the rear body control module (RBCM) connector.

• Inspect the connector engagement and connection condition and inspect the terminals for damage, deformation, corrosion, or disconnection.

• Is the connector normal?

Yes

Go to the next step.

No

Repair or replace the connector, then go to Step 6.

5

• Verify that the trunk lid opener switch (interior) and rear body control module (RBCM) connectors are disconnected.

• Inspect for continuity between trunk lid opener switch (interior) terminal A (wiring harness-side) and body ground.

• Is there continuity?

Yes

Refer to the wiring diagram and verify whether or not there is a common connector between rear body control module (RBCM) terminal 2O and trunk lid opener switch (interior) terminal A.

If there is a common connector:

• Determine the malfunctioning part by inspecting the common connector and the terminal for corrosion, damage, or pin disconnection, and the common wiring harness for a short to ground.

• Repair or replace the malfunctioning part.

If there is no common connector:

• Repair or replace the wiring harness which has a short to ground.

Go to the next step.

No

Go to the next step.

6

• Always reconnect all disconnected connectors.

• Reconnect the negative battery cable.

  (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.5].)

• Clear the DTC for the rear body control module (RBCM) using the M-MDS.

  (See CLEARING DTC [REAR BODY CONTROL MODULE (RBCM)].)

• Retrieve the rear body control module (RBCM) DTCs using the M-MDS.

  (See DTC INSPECTION [REAR BODY CONTROL MODULE (RBCM)].)

• Is the same DTC displayed?

Yes

Repeat the inspection from Step 1.

• If the malfunction recurs, replace the rear body control module (RBCM).

  (See REAR BODY CONTROL MODULE (RBCM) REMOVAL/INSTALLATION.)

Go to the next step.

No

Go to the next step.

7

• Are any other DTCs displayed?

Yes

Repair or replace the malfunctioning part according to the applicable DTC troubleshooting.

(See DTC TABLE [REAR BODY CONTROL MODULE (RBCM)].)

No

DTC troubleshooting completed.