Description

Instrument cluster configuration error

Detection condition

• Instrument cluster configuration error detected.

Fail-safe function

• Blind spot monitoring (BSM) system is stopped.

Possible cause

• Instrument cluster configuration error

• BSM control module malfunction

System wiring diagram

Not applicable

Step

Inspection

Action

1

• Using the M-MDS, perform the instrument cluster configuration (using As-Built data).

  (See INSTRUMENT CLUSTER CONFIGURATION (USING AS-BUILT DATA).)

• Clear the DTC for the BSM control module using the M-MDS.

  (See CLEARING DTC [BLIND SPOT MONITORING (BSM)].)

• Retrieve the BSM control module DTCs using the M-MDS.

  (See DTC INSPECTION [BLIND SPOT MONITORING (BSM)].)

• Is the same DTC displayed?

Yes

Using the M-MDS, perform the instrument cluster configuration (using As-Built data) again, then go to the next step.

(See INSTRUMENT CLUSTER CONFIGURATION (USING AS-BUILT DATA).)

No

Go to Step 3.

2

• Clear the DTC for the BSM control module using the M-MDS.

  (See CLEARING DTC [BLIND SPOT MONITORING (BSM)].)

• Retrieve the BSM control module DTCs using the M-MDS.

  (See DTC INSPECTION [BLIND SPOT MONITORING (BSM)].)

• Is the same DTC displayed?

Yes

Repeat the inspection from Step 1.

• If the malfunction recurs, replace the BSM control module.

  (See BLIND SPOT MONITORING (BSM) CONTROL MODULE REMOVAL/INSTALLATION.)

Go to the next step.

No

Go to the next step.

3

• Are any other DTCs displayed?

Yes

Repair or replace the malfunctioning part according to the applicable DTC troubleshooting.

(See DTC TABLE [BLIND SPOT MONITORING (BSM)].)

No

DTC troubleshooting completed.