Description

Error signal received from transmission/transaxle

Detection condition

• Instrument cluster received the error signals from the transmission/transaxle for 1 s or more with the ignition switched ON (engine off or on).

Fail-safe function

Not applicable

Possible cause

• The transaxle could not send a normal signal temporarily. (DTCs are stored in the TCM.)

• TCM malfunction

• Instrument cluster malfunction

System wiring diagram

Not applicable

Step

Inspection

Action

1

• Retrieve the TCM DTCs using the M-MDS.

  (See ON-BOARD DIAGNOSTIC SYSTEM DTC INSPECTION [FW6A-EL].)

• Are any DTCs displayed?

Yes

Repair or replace the malfunctioning part according to the applicable DTC troubleshooting.

(See ON-BOARD DIAGNOSTIC SYSTEM DTC TABLE [FW6A-EL].)

No

Go to the next step.

2

• Drive the vehicle at a vehicle speed of 30 km/h {19 mph} or more for 100 s or more.

• Retrieve the TCM DTCs using the M-MDS.

  (See ON-BOARD DIAGNOSTIC SYSTEM DTC INSPECTION [FW6A-EL].)

• Are any DTCs displayed?

Yes

Repair or replace the malfunctioning part according to the applicable DTC troubleshooting.

(See ON-BOARD DIAGNOSTIC SYSTEM DTC TABLE [FW6A-EL].)

No

Go to the next step.

3

• Clear the DTC for the instrument cluster using the M-MDS.

  (See CLEARING DTC [INSTRUMENT CLUSTER].)

• Switch the ignition ON (engine off or on) and wait for 20 s or more.

• Retrieve the instrument cluster DTCs using the M-MDS.

  (See DTC INSPECTION [INSTRUMENT CLUSTER].)

• Is the same DTC displayed?

Yes

Repeat the inspection from Step 1.

• If the malfunction recurs, replace the instrument cluster.

  (See INSTRUMENT CLUSTER REMOVAL/INSTALLATION.)

Go to the next step.

No

Go to the next step.

4

• Are any other DTCs displayed?

Yes

Repair or replace the malfunctioning part according to the applicable DTC troubleshooting.

(See DTC TABLE [INSTRUMENT CLUSTER].)

No

DTC troubleshooting completed.