DTC P0736:00

Gear reverse incorrect ratio

DETECTION CONDITION

• Speed ratio is 0.75 to 1.2 for 2,000 ms while vehicle is stopped in R position.

Diagnostic support note

• The check engine light does not illuminate.

• The automatic transaxle warning light illuminates if the TCM detects the above malfunction condition in two consecutive drive cycles or in one drive cycle while the DTC for the same malfunction has been stored in the TCM.

• PENDING CODE is available.

• FREEZE FRAME DATA is not available.

• DTC is stored in the TCM memory.

FAIL-SAFE FUNCTION

• Inhibits learning control.

• Inhibits neutral idle control.

POSSIBLE CAUSE

• ATF is less than specified value

• Clutch burnt

• Shift solenoid malfunction

• ATF leakage from clutch circuit

• Control valve body malfunction

SYSTEM WIRING DIAGRAM

Not applicable

STEP

INSPECTION

ACTION

1

• Are any the following DTCs displayed?

• P0738:00, P0746:00, P0751:00, P0752:00, P0756:00, P0757:00, P0761:00, P0762:00, P0766:00, P0767:00, P0771:00, P0772:00, P079A:00, P0842:00, P0843:00, P0847:00, P0848:00, P0872:00, P0873:00, P0877:00, P0878:00, P1784:00

Yes

Go to the applicable DTC inspection.

(See ON-BOARD DIAGNOSTIC SYSTEM DTC TABLE [FW6A-EL].)

No

Go to the next step.

2

• Inspect the ATF level.

  (See AUTOMATIC TRANSAXLE FLUID (ATF) INSPECTION [FW6A-EL].)

• Is there any malfunction?

Yes

Adjust the ATF level to the specification, then go to the next step.

(See AUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT [FW6A-EL].)

No

Go to the next step.

3

NOTE:

• If only DTCs in which the malfunctioning part is not confirmed are displayed as in the following DTCs, all of the diagnosis may not have been completed. In such cases, the malfunction cause can be determined by performing the on-board diagnostic test.

• Perform the on-board diagnostic test.

  (See ON-BOARD DIAGNOSTIC TEST MODE [FW6A-EL].)

• Are any DTCs present?

Yes

Go to the applicable DTC inspection.

(See ON-BOARD DIAGNOSTIC SYSTEM DTC TABLE [FW6A-EL].)

No

ATF amount in Step 2 is correct:

• Replace the automatic transaxle.

  (See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION [FW6A-EL].)

ATF amount adjusted in Step 2:

• Drive the vehicle to check it, and if there is no problem then the DTC troubleshooting is complete.