1. Remove the battery. (See BATTERY REMOVAL/INSTALLATION [SKYACTIV-G 2.5].)
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
4. After installation, add brake fluid, bleed the air, and inspect for fluid leakage. (See BRAKE FLUID AIR BLEEDING.)
| 1 | Brake fluid level sensor connector |
| 2 | Clutch reserve hose (MTX) |
| 3 | Brake pipe |
| 4 | Nut |
| 5 | Hose holder |
| 6 | Wiring harness |
| 7 | Bracket |
| 8 | Vacuum hose |
| 9 | Master cylinder |
| 10 | Cap |
| 11 | Brake fluid reserve tank |
| 12 | Cylinder component |
1. Disconnect the clutch reserve hose in the order shown in the figure.
1. Insert the clutch reserve hose into the master cylinder.
2. Pull the clutch reserve hose to verify that it does not come off, and reinsert it completely.