1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
3. After installation, pump the brake pedal a few times and inspect the following:
The disc pad projection is securely installed to the piston groove
Parking brake lever stroke
Brake drag
| 1 | Bolt (See Bolt Removal Note.) (See Bolt Installation Note.) |
| 2 | Disc pad |
| 3 | Shim |
| 4 | Guide plate |
1. Remove the rear caliper installation bolt shown in the figure and lift up the rear caliper.
1. Clean the exposed area of the piston.
2. Rotate the piston clockwise slowly using the SST and push the piston completely until the piston grooves are in the position shown in the figure.
3. Return the rear caliper to the original position and install the rear caliper installation bolt.