Tightening torque
108—147 N·m {12—14 Kgf·m, 80—108 ft·lbf}
1. When installing the wheels and tires, tighten the wheel nuts in a criss-cross pattern to the following tightening torque.
Tightening torque
108—147 N·m {12—14 Kgf·m, 80—108 ft·lbf}
1. If any brake line has been disconnected during the procedures, add brake fluid, bleed the brakes, and inspect for leakage after the procedure has been completed.
CAUTION:
Brake fluid will damage painted surfaces. Be careful not to spill any on painted surfaces. In addition, if there is any brake fluid on the wiring harness, the wire insulation may corrode causing a malfunction such as a short circuit. If brake fluid gets on a painted surface or wiring harness, wash and flush it off completely with water immediately.
1. Tighten the brake pipe flare nut using any commercially available flare nut wrench.
1. Disconnect the negative battery cable before performing any work that requires handling of connectors. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.5].)
1. Verify that there are no DTCs in the DSC memory after working on DSC related parts. If there are any DTCs in the memory, clear them. (See ON-BOARD DIAGNOSIS [DYNAMIC STABILITY CONTROL (DSC)].)
WARNING:
If the initialization procedure is not completed, the DSC will not operate properly and it might cause an unexpected accident. Therefore, when replacing the following parts, make sure to perform the initialization procedure to insure proper DSC operation.
1. When replacing the following parts, perform the initialization procedure. (See DSC RELATED PARTS SENSOR INITIALIZATION PROCEDURE.)
DSC HU/CM
SAS control module
CAUTION:
If the TPMS initialization procedure is performed with the tire pressures not to specification, the system may not operate normally. Therefore, always inspect and adjust the tire pressure of all 4 tires before performing the TPMS initialization procedure.
NOTE:
Perform the TPMS initialization when the following operations have been performed: (See TIRE PRESSURE MONITORING SYSTEM INITIALIZATION PROCEDURE.)
Tire pressures have been adjusted
Tires or wheels have been replaced
Tires have been rotated
DSC HU/CM replaced
DSC HU/CM connector disconnected
Battery is replaced
Negative battery cable is disconnected
1. Perform the TPMS initialization procedure when the TPMS warning light illuminates. (See TIRE PRESSURE MONITORING SYSTEM INITIALIZATION PROCEDURE.)