WARNING:
A hot engine and exhaust system can cause severe burns. Turn off the engine and wait until they are cool before removing the exhaust system.
CAUTION:
Do not allow flammable objects such as the taping for bundling a wiring harness to come into contact with the exhaust manifold and silencer.
NOTE:
If penetrant lubricating spray penetrates the airflow hole of the HO2S, it could cause interference with the HO2S function.
When removing the HO2S, wrap a rag around the lower position so that penetrant lubricating spray does not get sprayed into the airflow hole.
1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.5].)
2. Lift up the vehicle.
3. Remove the floor under cover. (With floor under cover) (See FLOOR UNDER COVER REMOVAL/INSTALLATION.)
4. Remove the insulator and brace bar. (See EXHAUST SYSTEM REMOVAL/INSTALLATION [SKYACTIV-G 2.5].)
5. Disconnect the HO2S connector.
6. Remove the clip C.
7. Remove the clip A and clip B from the bracket.
8. Remove the HO2S using the SST.
9. Install in the reverse order of removal.