System malfunction location

• U2300:54: Configuration error (data not received)

• U2300:55: Configuration error (no configuration)

• U2300:56: Configuration error (Ineffective/non-interchangeable data read)

• U2300:64: Configuration error (error value read)

Detection condition

• The vehicle control module detects configuration setting failure.

Fail-safe

• Inhibits the Mazda radar cruise control (MRCC) system control

• Inhibits the forward obstruction warning (FOW) system control

Possible cause

NOTE:

• If the vehicle control module is replaced with a new one, the configuration is re-performed within 6 s after the ignition is switched ON (engine off).

• After performing the configuration, DTC U2300:55 will be cleared if the ignition is switched ON (engine off) after the ignition is switched off.

• Module configuration procedure was not completed properly

• Correct data cannot be received from instrument cluster

• Vehicle control module (V/C-module) malfunction

System wiring diagram

• Not applicable

Step

Inspection

Action

1

• Switch the ignition ON (engine off) and wait for 6 s or more.

• Switch the ignition off (LOCK).

• Switch the ignition ON (engine off).

Go to the next step.

2

• Clear vehicle control module (V/C-module) DTCs using the M-MDS.

  (See CLEARING DTC [VEHICLE CONTROL MODULE (V/C-MODULE)].)

• Switch the ignition ON (engine on).

• Perform the vehicle control module (V/C-module) DTC inspection using the M-MDS.

  (See DTC INSPECTION [VEHICLE CONTROL MODULE (V/C-MODULE)].)

• Is the same DTC present?

Yes

Repeat the inspection from Step 1.

If the malfunction recurs, go to the next step.

No

Go to Step 5.

3

• Perform the instrument cluster DTC inspection using the M-MDS.

  (See DTC INSPECTION [INSTRUMENT CLUSTER].)

• Are any DTCs present?

Yes

Go to the applicable DTC inspection.

(See DTC TABLE [INSTRUMENT CLUSTER].)

After repairing the instrument cluster, perform the instrument cluster configuration.(See INSTRUMENT CLUSTER CONFIGURATION (USING AS-BUILT DATA).)

Then go to the next step.

No

Go to the next step.

4

• Clear vehicle control module (V/C-module) DTCs using the M-MDS.

  (See CLEARING DTC [VEHICLE CONTROL MODULE (V/C-MODULE)].)

• Switch the ignition ON (engine on).

• Perform the vehicle control module (V/C-module) DTC inspection using the M-MDS.

  (See DTC INSPECTION [VEHICLE CONTROL MODULE (V/C-MODULE)].)

• Is the same DTC present?

Yes

Repeat the inspection from Step 1.

• If the malfunction does not recur, go to the next step.

• If the malfunction recurs, replace the vehicle control module (V/C-module).

  (See VEHICLE CONTROL MODULE (V/C-MODULE) REMOVAL/INSTALLATION [MAZDA RADAR CRUISE CONTROL (MRCC) SYSTEM].)

Go to the next step.

No

Go to the next step.

5

• Verify other DTCs displayed.

• Are any other DTCs output?

Yes

Perform the corresponding DTC inspection.

No

DTC troubleshooting completed.